User-Definable Displays - GE C70 Instruction Manual

PRODUCT SETUP

5.3.15 User-definable displays

5.3.15.1 Menu
SETTINGS  PRODUCT SETUP  USER-DEFINABLE DISPLAYS
 USER-DEFINABLE
 DISPLAYS
This menu provides a mechanism for manually creating up to 16 user-defined information displays in a convenient
viewing sequence in the
facilitate text entry and Modbus register data pointer options for defining the user display content.
Once programmed, the user-definable displays can be viewed in two ways.
• Keypad — Use the
only the programmed screens are displayed). The screens can be scrolled using the up and down arrow keys. The
display disappears after the default message time-out period specified by the
 DEFAULT MESSAGE TIMEOUT
• User-programmable control input — The user-definable displays also respond to the
FlexLogic operand (in particular, the user-programmable pushbutton operands), can be used to navigate the
5
programmed displays.
On the rising edge of the configured operand (such as when the pushbutton is pressed), the displays are invoked by
showing the last user-definable display shown during the previous activity. From this moment onward, the operand
acts exactly as the down key and allows scrolling through the configured displays. The last display wraps up to the
first one. The
When the default timer expires (set by the
displays. The next activity of the
at the first user-defined display. The
5.3.15.2 User display 1(16)
SETTINGS  PRODUCT SETUP  USER-DEFINABLE DISPLAYS  USER DISPLAY 1(16)
 USER DISPLAY 1

Any existing system display can be automatically copied into an available user display by selecting the existing display and
pressing the
ENTER
indicates that the selected display has been added to the user display list. When this type of entry occurs, the sub-menus
are automatically configured with the proper content—this content can be edited subsequently.
5-112
INVOKE AND SCROLL:

Off
 USER DISPLAY 1


 USER DISPLAY 16


menu (between the
USER DISPLAY
key to select the
MENU USER DISPLAY
setting.
input and the down arrow key operate concurrently.
INVOKE AND SCROLL
DEFAULT MESSAGE TIMEOUT
INVOKE AND SCROLL
INVOKE AND SCROLL
DISP 1 TOP LINE:

DISP 1 BOTTOM LINE:

DISP 1 ITEM 1:

0
DISP 1 ITEM 5:

0
key. The display then prompts with ADD TO USER DISPLAY LIST? After selecting "Yes," a message
Range: FlexLogic operand
See below

and
TARGETS ACTUAL VALUES
menu item to access the first user-definable display (note that
setting), the relay starts to cycle through the user
input stops the cycling at the currently displayed user display, not
pulses must last for at least 250 ms to take effect.
Range: up to 20 alphanumeric characters
Range: up to 20 alphanumeric characters
Range: 0 to 65535 in steps of 1

Range: 0 to 65535 in steps of 1
C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
top-level menus). The sub-menus
PRODUCT SETUP  DISPLAY PROPERTIES
setting. Any
INVOKE AND SCROLL