Table of Contents
Advertisement
2.7.4
Fuse (1039)
The fuse is tested automatically when the instrument is started up and
then checked periodically during current measurement.
2.7.5
Buzzer
DISABLING/ENABLING THE BUZZER
Keep the ALARM button pressed down when you start up the instrument
by turning the switch. The
To reactivate the buzzer, switch the instrument OFF and then back ON
again.
THE DIFFERENT SOUNDS
When the
symbol is displayed, the buzzer is active. It gives out differ-
ent sounds, depending on the operation or warning.
• Short buzz (65 ms at 2kHz):
• Continuous buzz (at 2kHz):
•
Short, higher buzz (65ms at 4kHz):
•
Repeated high buzzes (at 4kHz):
greater than 25V and the yellow button is pushed
Shop for AEMC products online at:
16
symbol is no longer displayed.
- push on a button
- auto OFF
- measurement is lower than the minimum setpoint
- measurement is higher than the maximum setpoint
- when a disabled (inactive) button is pressed
(except the yellow test button)
- the detected voltage (safety check) at the sample is
ShopAEMC
www.
Digital Analog Megohmmeter Models 1035/1039
.ca
1.877.766.5412
Advertisement
Table of Contents
