Table of Contents
Advertisement
2.5.4
Scroll Cursor Button
When programming the alarm setpoints, the ▲ button is used to scroll
through the possible values for each parameter, which flashes:
-
MΩ or GΩ for insulation, kΩ or Ω for resistance, for the measure-
ment units,
-
1,2, 3 or _ for the thousands digit,
-
0, 1, 2, 3, 4, 5, 6, 7, 8 and 9 for the hundreds, tens and units,
-
"-.- - -" or "- -.- -" or "- - -.-" or "- - - -" for the decimal separator,
-
> or < for above or below threshold trigger.
-
When programming the capacitance per unit length in nF/km, the
▲ button can be used to change the values of the flashing digits
to 0, 1, 2, 3, 4, 5, 6, 7, 8 or 9.
2.5.5
Backlight Button
1035 and 1039: When this button is pressed, the backlighting of the dis-
play comes on. It will be turned off automatically one minute later. When it
is lit, you can turn the backlighting off by pressing this button again.
1039: When the switch is on 4000nF, a long press on this button enables
you to program the unit length value (see § 2.7.8).
2.5.6
REL Button
A long press on this button enables you to memorize a value. The
measurements that follow will be the positive or negative deviation
compared with the value memorized (does not function for voltage on the
MΩ positions).
Shop for AEMC products online at:
Digital Analog Megohmmeter Models 1035/1039
ShopAEMC
www.
.ca
1.877.766.5412
11
Advertisement
Table of Contents
