Table of Contents
Advertisement
2.7
Special Functions
2.7.1
Battery Life Indication
When you move the switch from the OFF position to one of the function
positions, the battery voltage is applied to the circuit. All the display seg-
ments light up at the same time for 1 second. Then all the segments go out
(for 2 seconds) except the
the size of the bargraph.
The bargraph indicates the battery charge life and the digital measurement
display indicates the charge life available (0.00 to 1.00 = 0 to 100%).
The instrument can be turned off at any time by turning the rotary switch
to OFF.
2.7.2
Auto-Off
After 5 minutes without any activity, the instrument automatically shuts off.
To start up the instrument again, press any one of the buttons, turn the
switch, or press the yellow test button on the remote control test probe.
DISABLING/ENABLING THE AUTO-OFF
•
To disable the Auto-Off, keep the
turning ON the instrument. The
cating that the Auto-Off function has been disabled.
•
To enable the Auto-off function, turn the instrument OFF and then
turn it back ON again. Auto-Off is the default mode.
2.7.3
Battery Auto Test
The battery supply voltage is measured automatically every second. The
battery voltage range for correct operation is 7V to 10V. There are four
possible cases:
•
The voltage is correct: Nothing is displayed.
•
The voltage is < 7.1V: the
life is limited.
•
The voltage is < 6.9V: the
accuracy is no longer assured. Replace the batteries.
•
The voltage is close to 6.7V: the digital display indicates BAT and
then, after 5 seconds, the shutdown buzzer sounds, and the Auto
Shop for AEMC products online at:
OFF function is activated. The instrument shuts down.
Digital Analog Megohmmeter Models 1035/1039
and the ◄ and ► symbols which delimit
symbol flashes. Remaining battery
symbol remains lit. Measurement
ShopAEMC
www.
button pressed down when
symbol is then displayed, indi-
.ca
1.877.766.5412
15
Advertisement
Table of Contents
