Remove The System Board Assembly - HPE ProLiant MicroServer Gen10 Series Troubleshooting Manual

Hide thumbs Also See for ProLiant MicroServer Gen10 Series:
Table of Contents

Advertisement

Remove the system board assembly

Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. If installed, remove the internal USB device.
2. To serve as a reference for system cable connections when the system board assembly is installed back
into the server, take a picture of the current system board cable connections.
3. Disconnect the following system cables:
Power supply cable
Optical drive or SSD SATA cable (optional)
LFF/SFF drive SATA cable – This cable can either be connected to the system board or to an installed
HBA.
Fan cable
4. Remove the system board assembly screw.
5. Place a finger in the notch on both sides of the system board assembly, and then pull out the assembly.
22
Remove the system board assembly

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProLiant MicroServer Gen10 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF