Configuration Example - HP 10500 Series Configuration Manual

Step
Enable IPv6.
2.
3. Enter tunnel interface view.
4. Configure an IPv6 address
for the tunnel interface.
5. Specify the ISATAP tunnel
mode.
6. Configure
address or interface for the
tunnel.
7. Return to system view.
8. Enable dropping of IPv6
packets
IPv4-compatible
addresses.

Configuration example

Network requirements
As shown in
host in the IPv4 network can access the IPv6 network.
Figure 74 Network diagram
IPv6 host
3002::2/64
Command
ipv6
interface tunnel number
•
•
tunnel-protocol ipv6-ipv4 isatap
a source
source { ip-address | interface-type
interface-number }
quit
using
tunnel discard ipv4-compatible-packet
IPv6
Figure 74, configure an ISATAP tunnel between the switch and the ISATAP host so the ISATAP
ISATAP switch
Vlan-int100
3001::1/64
IPv6 network
Service loopack port
Configure an IPv6 global unicast
address or site-local address:
ipv6 address { ipv6-address
prefix-length |
ipv6-address/prefix-length }
ipv6 address
ipv6-address/prefix-length
eui-64
Configure an IPv6 link-local
address:
ipv6 address auto link-local
ipv6 address ipv6 address
link-local
Switch
Vlan-int101
1.1.1.1/8
IPv4 network
ISATAP tunnel
GE1/0/3
Tunnel0
2001::5EFE:0101:0101/64
171
Remarks
By default, the IPv6 forwarding
function is disabled.
N/A
The IPv6 link-local address
configuration is optional.
By default:
•
No IPv6 global unicast
address is configured for the
tunnel interface.
•
A link-local address will
automatically be generated
when an IPv6 global unicast
address or link-local address
is configured.
By default, the tunnel mode is
GRE over IPv4.
The same tunnel mode should be
configured at both ends of the
tunnel. Otherwise, packet
delivery will fail.
By default, no source address or
interface is configured for the
tunnel.
N/A
Optional.
Disabled by default.
ISATAP host
IPv4 address:2.1.1.2/32
IPv6 address:
FE80::5EFE:0201:0102
2001::5EFE:0201:0102