HP 10500 Series Configuration Manual page 189

[SwitchA-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101, the physical interface of the tunnel.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 address 2001::1:1 64
[SwitchA-Vlan-interface101] quit
# Create service loopback group 1 and specify its service type as tunnel.
[SwitchA] service-loopback group 1 type tunnel
# Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP.
[SwitchA] interface GigabitEthernet 1/0/3
[SwitchA-GigabitEthernet1/0/3] undo stp enable
[SwitchA-GigabitEthernet1/0/3] undo lldp enable
[SwitchA-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchA-GigabitEthernet1/0/3] quit
# Create interface Tunnel 1.
[SwitchA] interface tunnel 1
# Specify an IPv4 address for interface Tunnel 1.
[SwitchA-Tunnel1] ip address 30.1.2.1 255.255.255.0
# Configure the tunnel encapsulation mode as IPv4 over IPv6.
[SwitchA-Tunnel1] tunnel-protocol ipv4-ipv6
# Specify the IP address of VLAN-interface 101 as the source address for interface Tunnel 1.
[SwitchA-Tunnel1] source 2001::1:1
# Specify the IP address of VLAN-interface 101 of Switch B as the destination address of interface
Tunnel 1.
[SwitchA-Tunnel1] destination 2002::2:1
# Apply service loopback group 1 on the tunnel.
[SwitchA-Tunnel1] service-loopback-group 1
[SwitchA-Tunnel1] quit
# Configure a static route destined for the IPv4 network Group 2 through interface Tunnel 1.
[SwitchA] ip route-static 30.1.3.0 255.255.255.0 tunnel 1
Configure Switch B:
•
# Enable IPv6.
<SwitchB> system-view
[SwitchB] ipv6
# Specify an IPv4 address for VLAN-interface 100.
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ip address 30.1.3.1 255.255.255.0
[SwitchB-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101, the physical interface of the tunnel.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ipv6 address 2002::2:1 64
[SwitchB-Vlan-interface101] quit
# Create service loopback group 1 and specify its service type as tunnel.
[SwitchB] service-loopback group 1 type tunnel
# Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP on the
interface.
180