Configuring An Ipv4 Over Ipv6 Tunnel; Configuration Prerequisites; Configuration Guidelines; Configuration Procedure - HP 10500 Series Configuration Manual

Last 300 seconds output:
5 packets input,
0 input error
9 packets output,
0 output error
# Ping the IPv4 address of the peer interface VLAN-interface 100 from Switch A.
[SwitchA] ping 10.1.3.1
PING 10.1.3.1: 56
Reply from 10.1.3.1: bytes=56 Sequence=1 ttl=255 time=15 ms
Reply from 10.1.3.1: bytes=56 Sequence=2 ttl=255 time=15 ms
Reply from 10.1.3.1: bytes=56 Sequence=3 ttl=255 time=16 ms
Reply from 10.1.3.1: bytes=56 Sequence=4 ttl=255 time=16 ms
Reply from 10.1.3.1: bytes=56 Sequence=5 ttl=255 time=15 ms
--- 10.1.3.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 15/15/16 ms

Configuring an IPv4 over IPv6 tunnel

Configuration prerequisites

Configure an IPv6 addresses for the interface (such as a VLAN interface or loopback interface) to be
configured as the source interface of the tunnel interface.

Configuration guidelines

Follow these guidelines when you configure an IPv4 over IPv6 tunnel:
• Specify public addresses or interfaces as the source and destination addresses for the tunnel
interfaces.
If the destination IPv4 network is not on the same subnet as the IPv4 address of the local tunnel
•
interface, you must configure a route destined for the destination IPv4 network through the tunnel
interface. You can configure a static route, and specify the local tunnel interface as the output
interface of the route or specify the IPv6 address of the peer tunnel interface as the next hop.
Alternatively, you can enable a dynamic routing protocol on both tunnel interfaces to achieve the
same purpose. For the detailed configuration, see Layer 3—IP Routing Configuration Guide.
Two or more local tunnel interfaces using the same encapsulation protocol must have different
•
source and destination addresses.
If you specify a source interface instead of a source address for a tunnel interface, the source
•
address of the tunnel interface is the primary IP address of the source interface.

Configuration procedure

To configure an IPv4 over IPv6 tunnel:
0 bytes/sec, 0 packets/sec
320 bytes
576 bytes
data bytes, press CTRL_C to break
178