HP 10500 Series Configuration Manual page 20

Configuration procedure
This example only describes multicast ARP configuration. For more information about IRF, see the IRF
configuration guide for switches. For NLB configuration on the servers, see the related documents for
Windows Server.
# Specify an IP address for VLAN-interface 10.
<Switch> system-view
[Switch] vlan 10
[Switch-vlan10] port GigabitEthernet 1/4/0/2
[Switch-vlan10] port GigabitEthernet 2/4/0/3
[Switch-vlan10] quit
[Switch] interface vlan-interface 10
[Switch-Vlan-interface10] ip address 16.1.1.1 255.255.255.0
[Switch-Vlan-interface10] quit
# Specify an IP address for VLAN-interface 20.
[Switch] vlan 20
[Switch-vlan20] port GigabitEthernet 2/3/0/1
[Switch-vlan20] port GigabitEthernet 1/3/0/4
[Switch-vlan20] quit
[Switch] interface vlan-interface 20
[Switch-Vlan-interface20] ip address 10.0.0.1 255.255.255.0
[Switch-Vlan-interface20] quit
# Disable the ARP entry check function.
[Switch] undo arp check enable
# Configure a static multicast MAC address entry.
[Switch] mac-address multicast 03bf-1001-0164 interface GigabitEthernet 1/4/0/2
GigabitEthernet 2/4/0/3 vlan 10
Verifying the configuration
• NLB load sharing—Enables the FTP server function of Server A and Server B. Host A and Host B
send requests to the virtual IP address, and each of them logs in to a different server.
NLB redundancy—Disables the network interface card of Server A. Host A and Host B send
•
requests to the virtual IP address, and both log in to the FTP server on Server B.
11