Configuring An Isatap Tunnel; Configuration Prerequisites; Configuration Guidelines; Configuration Procedure - HP 10500 Series Configuration Manual

Verifying the configuration
# Ping Host B from Host A or ping Host A from Host B. The ping operation succeeds.
D:\>ping6 -s 2002:201:101:1::2 2002:501:101:1::2
Pinging 2002:501:101:1::2
from 2002:201:101:1::2 with 32 bytes of data:
Reply from 2002:501:101:1::2: bytes=32 time=13ms
Reply from 2002:501:101:1::2: bytes=32 time=1ms
Reply from 2002:501:101:1::2: bytes=32 time=1ms
Reply from 2002:501:101:1::2: bytes=32 time<1ms
Ping statistics for 2002:501:101:1::2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 13ms, Average = 3ms

Configuring an ISATAP tunnel

Configuration prerequisites

Configure an IP addresses for the interface (such as a VLAN interface or loopback interface) to be
configured as the source interface of the tunnel interface.

Configuration guidelines

Follow these guidelines when you configure an ISATAP tunnel:
Specify public addresses or interfaces as the source and destination addresses for the tunnel
•
interfaces.
No destination address needs to be configured for an ISATAP tunnel because the destination IPv4
•
address is embedded in the ISATAP address.
• Because automatic tunnels do not support dynamic routing, you must configure a static route
destined for the destination IPv6 network at each tunnel end. You can specify the local tunnel
interface as the output interface of the route or specify the IPv6 address of the peer tunnel interface
as the next hop of the route. For the detailed configuration, see Layer 3—IP Routing Configuration
Guide.
The automatic tunnel interfaces using the same encapsulation protocol cannot use the same source
•
IP address.

Configuration procedure

To configure an ISATAP tunnel:
Step
1. Enter system view.
Command
system-view
170
Remarks
N/A