Displaying And Maintaining Proxy Arp; Common Proxy Arp Configuration Example; Network Requirements; Configuration Procedure - HP 10500 Series Configuration Manual

Step
3. Enable local proxy ARP.

Displaying and maintaining proxy ARP

Task
Display whether proxy ARP is
enabled.
Display whether local proxy ARP is
enabled.

Common proxy ARP configuration example

Network requirements

As shown in
different subnets separated by the switch (Host A belongs to VLAN 1 while Host D belongs to VLAN 2).
Configure proxy ARP on the switch to enable communication between the two hosts.
Figure 9 Network diagram
Host A
Host C

Configuration procedure

# Create VLAN 2.
<Switch> system-view
[Switch] vlan 2
Figure 9, Host A and Host D have the same IP prefix and mask, but they are located on
192.168.10.100/16
0000.0c94.36aa
Subnet A
Vlan-int1
192.168.10.99/24
Switch
Vlan-int2
192.168.20.99/24
Subnet B
192.168.20.200/16
0000.0c94.36dd
Command
local-proxy-arp enable [ ip-range
startIP to endIP ]
Command
display proxy-arp [ interface interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
display local-proxy-arp [ interface
interface-type interface-number ] [ | { begin
| exclude | include } regular-expression ]
Host B
Host D
17
Remarks
Disabled by default.
Remarks
Available in any view.
Available in any view.