Configuration Procedure - HP 10500 Series Configuration Manual

By default, sending ICMP destination unreachable packets is disabled. To enable it, use the ip
•
unreachables enable command.

Configuration procedure

To configure a tunnel interface:
Step
1. Enter system view.
2. Create a tunnel interface
and enter its view.
3. Configure a description
for the interface.
4. Apply
loopback group.
5. Set the MTU of the tunnel
interface.
6. Set the bandwidth for the
tunnel interface.
7. Restore
setting.
8. Shut down the tunnel
interface.
Command
system-view
interface tunnel number
description text
a service
service-loopback-group number
mtu mtu-size
tunnel bandwidth bandwidth-value
the default
default
shutdown
Remarks
N/A
By default, no tunnel interface is
created.
Optional.
By default, the description of a tunnel
interface is Tunnelnumber Interface.
By default, no service loopback group
is applied.
Optional.
The default MTU of the tunnel interface
depends on the status of the interface:
•
•
If you choose to manually set the MTU,
make sure the same MTU is configured
for all tunnel interfaces.
An MTU set on any tunnel interface is
effective on all existing tunnel
interfaces.
If you use this command multiple times,
the most recent configuration takes
effect.
Optional.
By default, the bandwidth for the tunnel
interface is 64 kbps.
Optional.
Optional.
By default, the tunnel interface is up.
161
If the tunnel interface is down, the
default MTU is 64000 bytes.
If the tunnel interface is up, the
default MTU is automatically
generated.