HP 10500 Series Configuration Manual page 195

# Specify the IP address of VLAN-interface 101 of Switch A as the destination address for interface
Tunnel 2.
[SwitchB-Tunnel2] destination 2001::11:1
# Apply service loopback group 1 on the tunnel.
[SwitchB-Tunnel2] service-loopback-group 1
[SwitchB-Tunnel2] quit
# Configure a static route destined to the IPv6 network Group 1 through interface Tunnel 2.
[SwitchB] ipv6 route-static 2002:1:: 64 tunnel 2
Verifying the configuration
# Display the status of the tunnel interfaces on Switch A and Switch B, respectively.
[SwitchA] display ipv6 interface tunnel 1
Tunnel1 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::2013:1
Global unicast address(es):
3001::1:1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF13:1
FF02::1:FF01:1
FF02::1:FF00:0
FF02::2
FF02::1
MTU is 1460 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
...
[SwitchB] display ipv6 interface tunnel 2
Tunnel2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::2024:1
Global unicast address(es):
3001::1:2, subnet is 3001::/64
Joined group address(es):
FF02::1:FF24:1
FF02::1:FF01:2
FF02::1:FF00:0
FF02::2
FF02::1
MTU is 1460 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
...
# Ping the IPv6 address of the peer interface VLAN-interface 100 from Switch A.
186