HP 10500 Series Configuration Manual page 174

[SwitchB-Tunnel0] ipv6 address 3001::2/64
[SwitchB-Tunnel0] source vlan-interface 100
[SwitchB-Tunnel0] destination 192.168.100.1
[SwitchB-Tunnel0] tunnel-protocol ipv6-ipv4
# Apply service loopback group 1 on the tunnel interface.
[SwitchB-Tunnel0] service-loopback-group 1
[SwitchB-Tunnel0] quit
# Configure a static route to IPv6 Group 1 through Tunnel 0 on Switch B.
[SwitchB] ipv6 route-static 3002:: 64 tunnel 0
Verifying the configuration
# Display the status of the tunnel interfaces on Switch A and Switch B, respectively.
[SwitchA] display ipv6 interface tunnel 0
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::C0A8:6401
Global unicast address(es):
3001::1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF00:1
FF02::1:FFA8:6401
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives:
...
[SwitchB] display ipv6 interface tunnel 0
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::C0A8:3201
Global unicast address(es):
3001::2, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF00:1
FF02::1:FFA8:3201
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
55
165