Enabling Dhcp; Enabling The Dhcp Server On An Interface - HP 10500 Series Configuration Manual

Step
3. Configure
DHCP option.
See Table 2
Table 2 Common DHCP options
Option Option name
3 Router Option
6 Domain Name Server Option
15 Domain Name
NetBIOS over TCP/IP Name
44
Server Option
NetBIOS over TCP/IP Node Type
46
Option
66 TFTP server name
67 Bootfile name
43 Vendor Specific Information

Enabling DHCP

Enable DHCP to validate other DHCP configurations.
To enable DHCP:
Step
1. Enter system view.
2. Enable DHCP.

Enabling the DHCP server on an interface

Perform this task to enable the DHCP server on an interface. Upon receiving a DHCP request on the
interface, the DHCP server assigns an IP address and other configuration parameters from the DHCP
address pool to the DHCP client.
a self-defined
for a description of common options and corresponding commands.
Command
system-view
dhcp enable
Command
option code { ascii ascii-string |
hex hex-string&<1-16> |
ip-address ip-address&<1-8> }
Corresponding command
gateway-list
dns-list
domain-name
nbns-list
netbios-type
tftp-server
bootfile-name
N/A
46
Remarks
No self-defined DHCP option is
configured by default.
Command parameter
ip-address
ip-address
ascii
ip-address
hex
ascii
ascii
hex
Remarks
N/A
The default setting is disabled by
default.