Configuring Snmp - Vezco VZ-NVR3200-4HD Quick Start Manual

Step 3 Check the Enable NTP checkbox to enable this feature.
Step 4 Configure the following NTP settings:
Interval: Time interval between the two synchronizing actions with NTP server. The
unit is minute.
NTP Server: IP address of NTP server.
NTP Port: Port of NTP server.
Step 5 Click the Apply button to save and exit the interface.
The time synchronization interval can be set from1 to 10080min, and the default value is
60min. If the NVR is connected to a public network, you should use a NTP server that has
a time synchronization function, such as the server at the National Time Center (IP
Address: 210.72.145.44). If the NVR is setup in a more customized network, NTP software
can be used to establish a NTP server used for time synchronization.
12.2.4
Purpose:
You can use SNMP protocol to get device status and parameters related
information.
Step 1 Enter the Network Settings interface.
Menu >Configuration> Network
Step 2 Select the SNMP tab to enter the SNMP Settings interface, as shown in Figure 12-
13.
Step 3 Check the SNMP checkbox to enable this feature.
Step 4 The enabling of SNMP may cause security problems. Click Yes to continue or No to
cancel the operation.
Network Video Recorder User Manual
Figure 12-12 NTP Settings Interface

Configuring SNMP

Figure 12-13 SNMP Settings Interface