Keysight 9000 Series Service Manual page 96

Chapter 5: Replacing Assemblies
To remove and replace the front panel bezel, front panel keyboard, touch screen, and Autoprobe
board
Figure 29
Remove these two screws and the
two on the other side of the
touch screen
18 Final Reassembly Note: When performing these procedures in reverse to reassemble the instrument, be
sure to fully press in on all edges (inner and outer edges) when you place the front bezel back on the
oscilloscope.
19 Final Reassembly Note: Before reassembling the front chassis, be sure all cables are pulled through
their appropriate openings and/or reattached to any boards located on the back side of the front chassis.
Once you close the chassis, it can be difficult to reach into these small holes and pull the cables through.
20 Final Reassembly Note: Before placing the rear cover back on the oscilloscope, be sure to reattach the
removable hard drive cover.
Figure 30
Removable
hard drive
cover
96
This board should already
be removed so you can pull the
touch screen cable through from
the other side of the sheet metal