Keysight 9000 Series Service Manual page 94

Chapter 5: Replacing Assemblies
To remove and replace the front panel bezel, front panel keyboard, touch screen, and Autoprobe
board
Figure 25
Remove these
two screws
Once the screws are
removed, disengage
this latch and the one
on the other side to
lift up and remove
board
15 To remove the touch screen, you will need to access the back side of the sheet metal it is attached to in
order to disconnect cables. There are two T15 screws on either side of the oscilloscope that need removed
(Figure 26) and then the front chassis will open up as shown in Figure 27.
Figure 26
This is the upper
right side screw
that needs
removed to open up
the front chassis.
There is also a lower
right side screw and
two more on the left
side
Note that this picture shows the front panel keyboard still attached but if you have followed
the directions exactly to this point, it will already be removed
94
The other
latch