Keysight 9000 Series Service Manual page 91

Figure 20
Touch screen
10 The next step is to remove the front panel keyboard from the plastic covering. There are a series of six
tabs around the outside edge holding the plastic covering to the keyboard. Disengage all of these and
then separate the two pieces as shown in Figure 21 and Figure 22.
Chapter 5: Replacing Assemblies
front panel bezel, front panel keyboard, touch screen, and Autoprobe board
Cable plugs into the connection closest to the
touch screen
To remove and replace the
Be sure that this cable
does not fall through
this opening. When
you reattach the cable
to the front panel
keyboard, you will need
it to be accessible. If it
does fall through the
opening then either use
tweezers to get it or
open up the front chassis
as described in Step 15.
91