Keysight 9000 Series Service Manual page 4

The Keysight Technologies Infiniium 9000 Oscilloscope at a Glance
Ease of use with high performance
The Keysight Technologies Infiniium oscilloscopes
combine unprecedented ease-of-use with high-
performance digitizing oscilloscope functionality to
simplify your design and analysis measurement
tasks.
• Traditional oscilloscope front-panel interface
provides direct access to the controls needed
for most troubleshooting tasks.
• Graphical user interface with menus, windows,
dialog boxes, and toolbars provides easy access
to dozens of configuration and analysis tools,
ensuring you can set up and make the most
complex measurements.
• Models with bandwidths from 250 MHz to
4 GHz.
Display shows waveforms and graphical user
interface
• Graphical interface allows direct interaction
with waveforms, including drag-and-drop
positioning and instant waveform zoom.
• Touchscreen display allows oscilloscope
operation without an external pointing device.
• Waveforms displayed in color, making
correlation easy.
• Current configuration parameters displayed
near the waveform display and are color-coded
to make identification easy.
• Graphical interface menus and toolbars simplify
complex measurement setups.
Horizontal controls set sweep speed and position
• Main sweep speeds from 5 ps/div to 20 s/div.
• Intensified waveforms on main sweep window
make it easy to see what will appear in the zoom
window.
4
Acquisition and general controls start and stop the
scope and do basic setup
• Run and stop controls for continuous or single
acquisitions.
• Clear display before one or more acquisitions.
• Default setup and Autoscale set initial
configuration.
Hard disk drive and USB 2.0 port for saving and
restoring setups and measurement results
• Store measurement displays for inclusion in
reports and test setup guides.
• Store oscilloscope setups to repeat tests
another time.
• Hard disk stores oscilloscope operating system.
Trigger setup controls set mode and basic
parameters
• Select Edge, Glitch, or Advanced Modes.
• Choose input source and slope.
• Use graphical user interface to simplify
configuration of pattern, state, delay, and
violation trigger modes.
Vertical controls set attenuation and position
• Input attenuation adjustable from 1 mV/div to 1
V/div.
• Color-coded knobs make it easy to find the
controls that affect each waveform.
Marker and quick measurements help measure
waveform parameters
• Waveform markers A and B to check voltage or
Δ-time at any point on the displayed waveform.
Service Policy
The service policy of this instrument requires
replacing defective assemblies. Some assemblies
can be replaced on an exchange basis.