Configuring The Communication Port Settings - GE Multilin EPM 2200 Instruction Manual

PROGRAMMING USING THE FACEPLATE

6.1.12 Configuring the Communication Port Settings

Note
6–12
2. Press ENTER when Cnct is the "active" parameter (i.e. it is in the A screen and
flashing).
This will display the Cnct (Connection) screen. To change this setting, use the RIGHT button
to scroll through the three settings. Select the setting that is right for your meter.
The possible Connection configurations are
• 3-element Wye (3 EL WYE)
• 2.5-element Wye (2.5EL WYE)
• 2 CT Delta (2 Ct deL)
as shown below:
3-Element Wye
3. Press ENTER to scroll through the other CFG parameters.
4. Press DOWN or RIGHT to display the Password screen (see Reset Mode on
page 6–4 for details).
5. Press MENU to return to the main Configuration menu.
Use the following procedure to program the communication port (POrt) settings of the
RS485 port if you have an EPM 2200 meter with Com Option S: RS485/KYZ output.
If you have an EPM 2200 meter with Com Option B (BACnet), the RS485 port is used only for
BACnet and is not programmed.
1. Push the DOWN Button to scroll through the configuration mode parameters.
2. Press ENTER when POrt is the active parameter (i.e. it is in the A screen and
flashing) as shown below.
CHAPTER 6: USING THE METER
2.5-Element Wye
EPM 2200 POWER METER – INSTRUCTION MANUAL
2 CT Delta