Table of Contents
Advertisement
CHAPTER 6: USING THE METER
EPM 2200 POWER METER – INSTRUCTION MANUAL
3.
Press ENTER to scroll through the configuration parameters, starting at the
SCrL Ct Pt screen.
4.
Push the DOWN Button to scroll all the parameters: scroll, CT, PT, connection
(Cnct) and port.
The active parameter is always flashing and displayed in the A screen.
Programming the screen for configuration mode.
1.
Press the DOWN or RIGHT button (for example, from the Ct-n message below)
to display the password screen, if enabled in the software.
2.
Use the DOWN and RIGHT buttons to enter the correct password (refer to
Reset Mode on page 7–4 for steps on password entry).
3.
Once the correct password is entered, push ENTER.
The Ct-n message will reappear, the PRG faceplate LED will flash, and the first
digit of the "B" screen will also flash.
4.
Use the DOWN button to change the first digit.
5.
Use the RIGHT button to select and change the successive digits.
6.
When the new value is entered, push ENTER twice.
This will display the Stor ALL? no screen.
PROGRAMMING USING THE FACEPLATE
6–7
Hide quick links:
Advertisement
Table of Contents
