Enter Password (If Enabled) - GE Multilin EPM 2200 Instruction Manual

CHAPTER 6: USING THE METER
Note
Note
6.1.6

Enter Password (if enabled)

EPM 2200 POWER METER – INSTRUCTION MANUAL
.
• If you push ENTER again, the Main Menu continues to scroll. (The DOWN button does
not change the screen.)
• If you push the RIGHT button, the rSt All? YES screen appears. Press Enter to perform
a reset.
CAUTION! All Max and Min values will be reset.
If Password protection is enabled in the software for reset, you must enter the four
digit password before you can reset the meter.
2. Once you have performed a reset, the screen displays rSt ALL donE and then resumes
auto-scrolling parameters.
If PASSWORD is Enabled in the software (see 6.4.3 Device Profile Settings on page 6–20 to
Enable/Change Password), a screen appears requesting the Password. PASS appears in the
A Screen and 4 dashes in the B Screen. The LEFT digit is flashing.
1. Use the DOWN button to scroll from 0 to 9 for the flashing digit. When the correct
number appears for that digit, use the RIGHT button to move to the next digit.
Example: On the Password screens below:
• On the left screen, four dashes appear and the left digit is flashing.
• On the right screen, 2 digits have been entered and the third digit is flashing.
PROGRAMMING USING THE FACEPLATE
6–5