GE Multilin EPM 2200 Instruction Manual page 71

CHAPTER 6: USING THE METER
EPM 2200 POWER METER – INSTRUCTION MANUAL
The following parameters can be configured through the POrt menu
• The meter Address (Adr, a 3-digit number).
• The Baud Rate (bAUd). Select from "9600", "19.2", "38.4", and
"57.6" for 9600, 19200, 38400, and 57600 kbps, respectively.
• The Communications Protocol (Prot). Select "rtU" for Modbus
RTU, and "ASCI" for Modbus ASCII.
• The first POrt screen is Meter (Adr). The current address appears on the screen.
Select a three-digit number for the address.
Refer to Programming the Configuration Mode Screens above for details on changing
values.
• The next POrt screen is the baud rate (bAUd). The current baud rate is displayed on
the "B" screen. Refer to Programming the Configuration Mode Screens above for
details on changing values. The possible baud rate screens are shown below.
• The final POrt screen is the Communications Protocol (Prot).
The current protocol is displayed on the "B" screen.
PROGRAMMING USING THE FACEPLATE
Address 005
6–13