Resetting The Ethernet Card; Using The Epm 2200 Meter's Web Interface; Home Web Page - GE Multilin EPM 2200 Instruction Manual

CHAPTER 7: COM OPTION B: BACNET MS/TP WITH MODBUS TCP/IP
7.3.1

Resetting the Ethernet Card

7.4

Using the EPM 2200 Meter's Web Interface

7.4.1

Home web page

Note
NOTE
EPM 2200 POWER METER – INSTRUCTION MANUAL
The Ethernet card's Reset Button is accessed from the back of the EPM 2200 meter. See
figure below for button location.
Figure 7-1: Backplate of EPM 2200 meter, showing Reset Button placement
Using an implement such as a ballpoint pen tip, press and hold the Reset button for 30
seconds. The Ethernet card will be reset to its default settings.
As shown in Section 7.3, you can use the meter's web interface to change the IP address
and other Network parameters. You can also view information and readings using the web
interface. This section explains the web pages other than the BACnet MS/TP Settings and
Activate Configuration web pages, which are explained in Section 7.3.
The Home web page is shown at the top of page 7–8. It is the first page you see when you
connect to the meter.
To access this web page from any of the other pages, click Home on the left side of the
page.
USING THE EPM 2200 METER'S WEB INTERFACE
Reset Button
7–11