Table of Contents
Advertisement
4.3.7
Configuring the Communication Port Setting
4–14
Push the DOWN Button to scroll through the configuration mode
parameters.
Press ENTER when
screen and flashing).
This will display the
(connection) screen. The possible connection configurations are
Cnct
3-element Wye (
3 EL WYE
shown below.
3-Element Wye
Press ENTER to scroll through the other
Press DOWN or RIGHT to display the password screen (see Reset
Mode and Password Entry on page 4–6 for details).
Press MENU to return to the main configuration menu.
Use the following procedure to program the communication port (
Push the DOWN Button to scroll through the configuration mode
parameters.
Press ENTER when
screen and flashing).
The following parameters can be configured through the
• The meter address (
• The baud rate (
bAUd
38400, and 57600 kbps, respectively.
• The communications protocol (
is the active parameter (i.e. it is in the "A"
Cnct
), 2.5-element Wye (
2.5EL WYE
2.5-Element Wye
is the active parameter (i.e. it is in the "A"
POrt
, a 3-digit number).
Adr
). Select from "9600", "19.2", "38.4", and "57.6" for 9600, 19200,
).
Prot
EPM 6000 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
CHAPTER 4: USING THE METER
), and 2 CT Delta (
2 Ct deL
2 CT Delta
parameters.
CFG
) settings.
POrt
menu
POrt
), as
Advertisement
Table of Contents
