Advertisement
7.3.9
Configuring the Communication Port Setting
7–12
3-Element Wye
3.
Press ENTER to scroll through the other
4.
Press DOWN or RIGHT to display the Password screen (see Reset Mode above
for details).
5.
Press MENU to return to the main Configuration menu.
Use the following procedure to program the communication port (
1.
Push the DOWN Button to scroll through the configuration mode parameters.
2.
Press ENTER when
flashing) as shown below.
The following parameters can be configured through the
•
The meter Address (
•
The Baud Rate (
"57.6" for 9600, 19200, 38400, and 57600 kbps, respectively.
•
The Communications Protocol (
RTU, and "ASCI" for Modbus ASCII.
• The first
screen is Meter Address (
POrt
screen. Follow the programming steps in section 7.3.5. Select a three-digit number
for the address.
CHAPTER 7: CONFIGURING THE METER USING THE FRONT PANEL
2.5-Element Wye
parameters.
CFG
is the active parameter (i.e. it is in the "A" screen and
POrt
POrt
, a 3-digit number).
Adr
). Select from "9600", "19.2", "38.4", and
bAUd
Prot
). The current address appears on the
Adr
EPM 2200 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
2 CT Delta
) settings.
POrt
menu
). Select "rtU" for Modbus
Advertisement
