Installing Mounting Flanges For A 23-Inch Rack - Nortel CVX 1800 Hardware Installation Manual

Installing Mounting Flanges for a 23-Inch Rack

If you are using a 23-inch rack, find the wide mounting flanges and screws in the
accessory kit. These flanges are optional and may not be included in your
shipment.
To attach the wide mounting flanges, follow these steps:
Step
1
2
3
4
5
296-1011-200 Rel. 5.0, Doc. Rev. 08.01
Action
Remove the 19-inch mounting flanges from both sides of the chassis.
Decide which mounting holes you want to use (either flush-mount or
mid-mount) on one side of the chassis.
Position the mounting flange so that the holes in the flange align with
the corresponding holes in the chassis.
Start each screw by hand, then use the Phillips screwdriver to tighten
the screws to 25 in-lb.
1 CVX 18o
2 o
3
4
5
6
7
8
9
10
11
12
Power
Failed
Good
Redun
Yellow
Red
Repeat steps 1 through 3 for the other mounting flange.
Plastic Fascia Chassis Installation
Installing the CVX 1800 Chassis
ESD
Jack
13
14
15
16
17
18
Turn clockwise
to tighten screws
to 25 in-lb.
2-19