CVX 1800 Hardware Installation Guide
Preparing for the CVX 1800 Installation
Checking the Shipment
Carefully inspect the shipment for completeness, ensuring the items in the
shipping container match those on the packing list affixed to the shipping
container. In particular:
•
Confirm that the shipment includes any additional cables you have ordered.
•
Check all items for shipping damage.
Tools and Equipment Needed
Before you install the CVX 1800 chassis, ensure that you have all of the necessary
tools, cables, console equipment, and mounting hardware.
Tools
You must have the following tools:
•
Screwdrivers:
— Phillips #2 screwdriver
— Torque screwdriver for securing DC power cables using loop connectors
— 1/16-inch and 1/4-inch flat-tip screwdrivers
•
Nut drivers (nonmetric sizes) for securing power and ground cabling
•
Torque wrench
•
9/16-inch wrench for removing shipping bolts
•
Volt/ohm meter for power connections
1-14
Note: If you detect or suspect any damage, do not install the CVX 1800
chassis. See
"Technical Support"
on
page
xxiv.
296-1011-200 Rel. 5.0, Doc. Rev. 08.01