Connecting A Modem - Nortel CVX 1800 Hardware Installation Manual

CVX 1800 Hardware Installation Guide
Connecting Equipment to the Console Port

Connecting a Modem

To connect a modem to the CVX 1800, follow these steps:
Step
1
2
3
3-46
Action
Turn on the modem, then configure it using the parameters listed
below.
For instructions, see the documentation for the modem.
Modem Parameter
Baud rate
Auto answer
Clear to send (CTS) signal
Data terminal ready (DTR) signal
Data carrier detect (DCD) signal
Local character echo
Supervisory functions
Data set ready (DSR) signal
Turn off the modem.
Remove the console cable from the console port.
Value/State
56 Kb/s (or less)
Set to n rings with DTR active.
(The value n must be greater than
0. If the value is 0, Auto answer is
disabled.)
Always on
DTR signal fail-disconnect
enabled. Return to command
mode; Auto answer is disabled.
DCD signal on while carrier
present. (The CVX 1800 uses the
DCD signal to detect a modem
disconnect.)
Off
Off
On
296-1011-200 Rel. 5.0, Doc. Rev. 08.01