Connecting Customer-Supplied Dc Power Source; Prerequisites; Removing The Protective Cover - Nortel CVX 1800 Hardware Installation Manual

Connecting Customer-Supplied DC Power Source

The DC power source is one of the options for supplying power to the CVX 1800.

Prerequisites

Before connecting the CVX 1800 to a DC power source, see
Warnings"

Removing the Protective Cover

To remove the cover, follow this step:
Step
1
296-1011-200 Rel. 5.0, Doc. Rev. 08.01
on page vii.
Caution: Ensure that the wire gauge you use is adequate for the distance
between the CVX 1800 and the DC power source. Before connecting
power cables to the CVX 1800, use a volt/ohm meter to ensure that the
power cables are not live.
Action
Remove the clear protective cover by removing the two screws on the
cover.
Phillips
screwdriver
Connecting Power to the Chassis
Turn counterclockwise
to loosen screws.
Chassis Connections
"DC Power Supply
CVX-0068A
3-25