Installation Procedures; Connecting The Power Cord - Advantech TREK-733L User Manual

2.2 Installation Procedures

STEP 1:
When you install TREK-733L, the first step will connect the power and ignition cor-
rectly. TREK-733L power cable is designed to connect battery directly. TREK-733L
can be switched ON/OFF by the ignition signal. In case of OS/APP hang, reset button
is available for system boot up.

2.2.1 Connecting the Power Cord

STEP 2:
Connect the High Density Cable (HDC) to the DC inlet of TREK-733L. On the open-
wire end, one pin is reserved for positive voltage and is marked "B+" which needs to
be connected to the power "+" side; one pin is reserved for ground and is marked
"GND"; which needs to be connected to the power "-" side. And, one pin is reserved
for the ignition signal with an "ACC" mark.
Table 2.1: Pin Definition of Power Cord
Pin
1
2
3
Figure 2.4 HDC Connector &Power/IO Cable photo (HDC)
TREK-733L User Manual
Definition
+ (B+)
-(GND)
Ignition (ACC)
10
Color
Red
Black
Green
+(B+)
Ignition(ACC)
-(GND)