Table of Contents
Advertisement
8 SECURITY
Viewing the settings in template mode also modifies the settings tree, showing only the settings categories that contain
editable settings. The effect of applying the template to a typical settings tree view is shown below.
Typical settings tree view without template applied.
Figure 8–5: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE SETTINGS COMMAND
Use the following procedure to display settings available for editing and settings locked by the template.
1.
Select an installed device or a settings file from the tree menu on the left of the EnerVista UR Setup main screen.
2.
Apply the template by selecting the Template Mode > View All Settings option.
3.
Enter the template password then click OK to apply the template.
Once the template has been applied, users will only be able to edit the settings specified by the template, but all settings
will be shown. The effect of applying the template to the phase time overcurrent settings is shown below.
Phase time overcurrent settings window without template applied.
Figure 8–6: APPLYING TEMPLATES VIA THE VIEW ALL SETTINGS COMMAND
e) REMOVING THE SETTINGS TEMPLATE
It may be necessary at some point to remove a settings template. Once a template is removed, it cannot be reapplied and
it will be necessary to define a new settings template.
1.
Select an installed device or settings file from the tree menu on the left of the EnerVista UR Setup main screen.
2.
Select the Template Mode > Remove Settings Template option.
3.
Enter the template password and click OK to continue.
GE Multilin
C70 Capacitor Bank Protection and Control System
8.2 SETTINGS SECURITY
Typical settings tree view with template applied via
the
Template Mode > View In Template Mode
command.
Phase time overcurrent window with template applied via
the
Template Mode > View All Settings
The template specifies that only the
Pickup
settings be available.
842860A1.CDR
command.
and
Curve
842859A1.CDR
8-9
8
Advertisement
Table of Contents
