HP 830 Command Reference Manual page 131

device-type: Sets a device type value, ranging from 0 to 2. Value 0 specifies a DHCP server. Value 1
specifies a switch. Value 2 specifies an LLDP-MED endpoint.
country-code: Sets a country code, corresponding to ISO 3166.
{ ca-type ca-value }&<1- 1 0>: Configures address information, where ca-type represents the address
information type, ranging from 0 to 255, ca-value represents address information, a string of 1 to 250
characters, and &<1- 1 0> indicates that you can enter up to 10 parameters.
elin-address: Inserts telephone numbers for emergencies in location identification TLVs.
tel-number: Sets the telephone number for emergencies, a string of 10 to 25 characters.
network-policy: Advertises network policy TLVs.
power-over-ethernet: Advertises extended power-via-MDI TLVs.
Usage guidelines
To enable the device to advertise LLDP-MED TLVs, you must first enable it to advertise LLDP-MED
capabilities TLVs.
To disable the device from advertising LLDP-MED capabilities TLVs, you must first disable it from
advertising other LLDP-MED TLVs.
To disable the device from advertising MAC/PHY configuration/status TLVs, you must first disable it from
advertising LLDP-MED capabilities TLVs.
If you enable the device to advertise LLDP-MED capabilities TLVs, you also enable it to advertise
MAC/PHY configuration/status TLVs.
To enable the device to advertise multiple types of TLVs, you can execute the lldp tlv-enable command
repeatedly without the all keyword specified.
Examples
# Enable the device to advertise link aggregation TLVs of the IEEE 802.3 organizationally specific TLVs
on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp tlv-enable dot3-tlv link-aggregation
126