Link-Aggregation Port-Priority - HP 830 Command Reference Manual

Default
An aggregation group operates in static aggregation mode.
Views
Layer 2 aggregate interface view
Default command level
2: System level
Usage guidelines
To change the aggregation mode of an aggregation group that contains member ports, remove all the
member ports from the aggregation group first.
Examples
# Configure Layer 2 aggregation group 1 to operate in dynamic aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic

link-aggregation port-priority

Use link-aggregation port-priority to set the aggregation priority of a port.
Use undo link-aggregation port-priority to restore the default.
Syntax
link-aggregation port-priority port-priority
undo link-aggregation port-priority
Default
The aggregation priority of a port is 32768.
Views
Ethernet interface view
Default command level
2: System level
Parameters
port-priority: Specifies a port aggregation priority in the range of 0 to 65535. The smaller the value, the
higher the port aggregation priority.
Usage guidelines
When the number of ports eligible for becoming Selected ports exceeds the maximum number of
Selected ports allowed in an aggregation group, changing the aggregation priority of a port might
affect the aggregation state of the ports in the aggregation group.
Examples
# Set the aggregation priority of port Ten-GigabitEthernet 1/0/1 to 64.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] link-aggregation port-priority 64
80