HP 830 Command Reference Manual page 31

Table 5 Command output
Field
current state
Line protocol current state
Description
The Maximum Transmit Unit
Internet protocol processing
Physical is loopback
Last clearing of counters
Last 300 seconds input: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0
bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
The brief information of interface(s) under
route mode
Link: ADM - administratively down; Stby -
standby
Protocol: (s) - spoofing
Interface
Link
Description
Physical layer state of the interface:
•
Up—The physical layer state of the interface is up.
•
DOWN (Administratively)—The interface has been shut down
manually.
Data link layer protocol state of the interface. (UP) spoofing
means that the data link layer protocol state of the interface is UP,
but the corresponding link might not exist, or the corresponding
link is non-permanent and established on demand.
Description of the interface.
MTU of the interface.
State (enabled or disabled) of the network layer protocol
(displayed as Internet Address is X.X.X.X/XX Primary).
The physical type of the interface is loopback.
Last time when statistics on the logical interface were cleared by
using the reset counters interface command.
If the statistics have never been cleared since the device started,
this field displays Never.
Average input rate over the last 300 seconds in Bps, bps, and
pps.
Average output rate over the last 300 seconds in Bps, bps, and
pps.
Total number and size (in bytes) of input packets on the interface
and the number of dropped packets.
Total number and size (in bytes) of output packets on the interface
and the number of dropped packets.
Brief information about Layer 3 interfaces.
Explains the Link field values:
•
ADM—The interface has been administratively shut down. To
recover its physical state, use the undo shutdown command.
•
Stby—The interface is operating as a backup interface. To see
the primary interface, use the display standby state command
in High Availability Command Reference.
Explains the Protocol field value.
(s)—Represents spoofing. If the data link layer protocol of an
interface is up but its link is an on-demand link or not present at
all, the Protocol field displays UP(s).
Abbreviated interface name.
Physical layer state of the interface:
•
UP—The interface is up.
•
ADM—The interface has been administratively shut down. To
recover its physical state, use the undo shutdown command.
26