HP 830 Command Reference Manual page 41

Field
The Maximum Transmit Unit
Internet protocol processing :
disabled
Internet Address is
192.168.1.54/24 Primary
Internet Address is 6.4.4.4/24 Sub
IP Packet Frame Type
Hardware address
IPv6 Packet Frame Type
Last clearing of counters
The brief information of interface(s)
under route mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Cause
Related commands
reset counters interface vlan-interface
Description
MTU of a VLAN interface.
The interface is not capable of processing IP packets. This information
is displayed when the interface is not configured with an IP address.
The primary IP address of the interface is 192.168.1.54/24. This
information is displayed only if the primary IP address is configured for
the interface.
The secondary IP address of the interface is 6.4.4.4/24. This
information is displayed only if a secondary IP address is configured
for the interface.
IPv4 outgoing frame format.
MAC address corresponding to a VLAN interface.
IPv6 outgoing frame format.
Time when the reset counters interface vlan-interface command was
last used to clear the interface statistics.
Never indicates the reset counters interface vlan-interface command
has never been used on the interface after the device's startup.
Brief information about Layer 3 interfaces.
Link layer state of an interface:
•
ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown command.
•
Stby—The interface is operating as a standby interface. To see the
main interface, use the display standby state command.
If the network layer protocol state of an interface is shown as UP, but its
link is an on-demand link or not present at all, its protocol attribute
includes the spoofing flag (an s in parentheses).
Abbreviated interface name.
Physical link state of the interface:
•
UP—The link is up.
•
ADM—The link has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
Protocol connection state of the interface:
•
UP.
•
DOWN.
•
UP(s).
Main IP address of the interface.
Description of the interface.
Cause of a DOWN physical link. If the port has been shut down with
the shutdown command, this field displays Administratively. To restore
the physical state of the interface, use the undo shutdown command.
36