Lldp Timer Tx-Interval; Lldp Tlv-Enable - HP 830 Command Reference Manual

lldp timer tx-interval

Use lldp timer tx-interval to set the LLDP frame transmission interval.
Use undo lldp timer tx-interval to restore the default.
Syntax
lldp timer tx-interval interval
undo lldp timer tx-interval
Default
The LLDP frame transmission interval is 30 seconds.
Views
System view
Default command level
2: System level
Parameters
interval: Sets the LLDP frame transmission interval, ranging from 5 to 32768 seconds.
Usage guidelines
It is a good practice to set the LLDP frame transmission interval to be no less than four times the LLDP frame
transmission delay.
If the LLDP frame transmission interval is less than the LLDP frame transmission delay, the device uses the
LLDP frame transmission delay as the transmission interval.
Examples
# Set the LLDP frame transmission interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20
Related commands
lldp timer tx-delay

lldp tlv-enable

Use lldp tlv-enable to configure the types of advertisable TLVs for a port or all ports in a port group.
Use undo lldp tlv-enable to disable the advertising of the specified types of TLVs.
Syntax
lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] } |
dot3-tlv { all | link-aggregation | mac-physic | max-frame-size | power } | med-tlv { all | capability |
inventory | location-id { civic-address device-type country-code { ca-type ca-value }&<1- 1 0> |
elin-address tel-number } | network-policy | power-over-ethernet } }
undo lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id | vlan-name } | dot3-tlv { all |
124