Port Trunk Pvid - HP 830 Command Reference Manual

[Sysname-Bridge-Aggregation1] port trunk permit vlan 2
Please wait... Done.
Configuring Ten-GigabitEthernet1/0/1... Done.
Configuring Ten-GigabitEthernet1/0/2... Done.
The output shows that Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2 are the member ports
of the aggregation group corresponding to Bridge-Aggregation 1.
Related commands
port link-type

port trunk pvid

Use port trunk pvid to configure the PVID for the trunk port.
Use undo port trunk pvid to restore the default.
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
Default
The PVID of a trunk port is VLAN 1.
Views
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a trunk port. If you use the undo vlan command to
remove the PVID of a trunk port, it does not affect the setting of the PVID on the port.
The local and remote trunk ports must use the same PVID for the traffic of the PVID to be transmitted
properly.
You must use the port trunk permit vlan command to configure the trunk port to allow and forward
packets from the PVID.
The configuration made in Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and
•
moves to the next member port.
52