Flow-Interval; Interface - HP 830 Command Reference Manual

Parameters
auto: Sets the interface to operate in autonegotiation mode.
full: Sets the interface to operate in full duplex mode.
Usage guidelines
Support for this command varies with device models. For more information, see About the Command
References for HP Unified Wired-WLAN Products.
Examples
# Configure interface Ten-GigabitEthernet 1/0/1 to operate in autonegotiation mode.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] duplex auto

flow-interval

Use flow-interval to set the interface statistics polling interval.
Use undo flow-interval to restore the default interval.
Syntax
flow-interval interval
undo flow-interval
Default
The interface statistics polling interval is 300 seconds.
Views
Layer 2 Ethernet interface view
Default command level
2: System level
Parameters
interval: Sets the statistics polling interval, in seconds. It is in the range of 5 to 300 and must be a multiple
of 5.
Examples
# Set the statistics polling interval to 100 seconds on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] flow-interval 100

interface

Use interface to enter interface view.
Syntax
interface interface-type interface-number
12