Alternative Mode Programming - Honeywell GSMV4G Installation And Setup Manual

GSMV4G/GSMVCN4G Installation and Setup Guide

Alternative Mode Programming

Press the [ENTER] key to begin programming
operation being programmed.
NOTE: The central station can remotely block access to local
Table 3-4. Programming for Zone Trigger, 4204 Emulation, or Two-4204 Emulation modes.
PROMPTS
Strt Prog Mode?
1
(Y/N)_
Enter Password
2
Program Device?
3
(Y/N)_
Create Password?
4
(Y/N)_
Change Password?
5
(Y/N)
Enter Password
6
Verify Password
7
Exit Prog. Mode?
8
(Y/N)_
3-10
device programming. If this has been done, the following
prompt appears:
4204/
ZONE
2-4204
TRIG.
[Y], [N]
X X
[0-9, A-F, N, S,
X X
T, X, Y]
[Y], [N]
X X
[Y], [N]
X X
[Y], [N]
X X
[0-9, A-F, N, S,
X X
T, X, Y]
[0-9, A-F, N, S,
X X
T, X, Y]
[Y], [N]
X X
[ESC]
ollow the prompts for the mode of
and f
OPTIONS
Enters programming mode.
If a password has been previously assigned, this
prompt appears. Enter a 4-digit password (0-9, A-F,
N, S, T, X, Y).
The next prompt appears.
To begin programming the communicator, press [Y]
and go to Prompt 9: "Device Mode."
To create a password if none has been assigned,
press [N] and go to Prompt 4: "Create Password."
To change an existing password, press [N] and go to
Prompt 5: "Change Password."
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program Device?"
prompt.
If a password is desired, press [Y] and go to Prompt
6: "Enter Password."
If a password has already been assigned, this
prompt appears after pressing [N] at the "Program
Device?" prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key
when prompted for the new password and its
confirmation.
If [Y] was pressed in Prompt 4 or 5, this prompt
appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
Re-enter the password as confirmation.
If the password doesn't match the first entry, the
following is displayed followed by the "Exit Prog.
Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is
displayed directly.
Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode paragraph
in this Section.
Access to Prog
Mode Denied
DESCRIPTION