Mounting The Communicator; Mounting Procedure, Gsmv4G (No Rear Tamper Switch) - Honeywell GSMV4G Installation And Setup Manual

GSMV4G/GSMVCN4G Installation and Setup Guide

Mounting the Communicator

The communicator can be mounted in two ways depending on the installation requirements.
ULC NOTES:
For Commercial Fire installations, the communicator must be mounted to a single or double
gang box.
1. Locate the Drilling Template (provided) and align with case back. Drill at the appropri-
ate locations for either single or double gang box.
2. Locate the gang box into the mounting surface, align case back over mounting surface
and install using the screws provided. Pass wires/cables through the opening in the gang
box and then through the opening in the case back.
3. When all wiring is completed, attach the case front of the communicator to the case back.
Attach the top first then press the bottom section inward until it snaps into place. Secure
cover using supplied screw.
4. For Commercial Burglary installations, you must install the rear tamper switch.
UL

Mounting Procedure, GSMV4G (no rear tamper switch)

1. Locate the case back over selected mounting position such that the opening in the case
back is aligned with the wire/cable opening on the mounting surface.
2. Pass the wires/cable through the opening in the case back, or route through the
removable knockouts located on the back cover.
3. Secure the case back to the mounting surface using four screws (supplied).
When all wiring is completed, attach the case front. Position the top first, then press the
4.
bottom section until it snaps in place. Secure bottom using the supplied cover screw.
(This is required for UL installations.)
2-2
The cover must be secured with the supplied screw.
Standard Mounting