Elnec JetProg User Manual page 137

F10
F11
Arrow keys
Home/End
PgUp/PgDn
Ctrl+PgUp/PgDn jump on start / end current page
Ctrl+Home/End jump on start / end edit area
Backspace
Note: Characters 0 and 1 immediately changes content of
edit area.
Buffer / Fill block
Selecting this command causes filling selected block of buffer
by requested hex (or ASCII) string. Sets start and end block for
filling and requested hex or ASCII string.
Buffer / Copy block
This command is used to copy specified block of data in
current buffer on new address. Target address needn't be out
from source block addresses.
Buffer / Move block
This command is used to move specified block of data in
current buffer on new address. Target address needn't be out
from source block addresses. Source address block (or part)
will be filled by topical blank character.
Buffer / Swap block
This command swaps a high- and low- order of byte pairs in
current buffer block. This block must start on even address and
must have an even number of bytes. If these conditions do not
fulfil, the program modifies addresses itself (start address is
moved on lower even address and/or end address is moved on
higher odd address).
Buffer / Erase
If this command is selected, the content of the buffer will be
filled with topical blank character.
The reserved key <Ctrl+F2> will bring out this menu from any
menu and any time.
change mode view / edit
switch the mode of buffer data view
between 1 bit and 8 bit view. It can be
also do by mouse clicking on the button
to the right of View/Edit mode buffer
indicator. This button indicates actual
data view mode (1 bit or 8 bit), too.
move cursor up, down, right and left
jump on start / end current line
jump on previous / next page
move cursor one position left (back)
137
Software