Pressing
places the display into a temporary high resolution mode. This mode continues until
Fx-HiRes
pressed again, or power is cycled. In the Hi-Res mode the appropriate
Hi-Res mode does not increase the accuracy, but allows for smaller weight incrementation to display.
Use
or
ZERO
TARE
4.2.7 Print
The
function is set to
Print
scale will cause the Comm Port on the Remote to output the selected data string.
If an
is programmed as Print and the Print Setup is configured as continuous, then the
F-Key
.
Start Print/Stop Print
4.2.8 Total Remote Devices
Sensor summing must be enabled in the communications setup menu. If the
communications setup menu, then pressing
It is common to program F1 for SCAN and F2 for ttl.rd (Total Remote Devices) to allow quick switching between
individual channel displays (with Scan) or the summed weight (with ttL.rd).
4.3
Auto-Off
The
feature prolongs the battery life by powering off the unit when not in use. When a button is pressed or
Auto-Off
the detected load is in motion exceeding 10
When disabled, the unit will only turn off by pressing
To set the
function:
Auto-Off
1. Press and hold
2. Press
F2
to scroll to
3. Press
F1
. The current auto off time displays.
4. Press
F2
to scroll through the available times.
5. Press
F1
when the desired time is displayed.
6. Press
to exit setup and store the settings.
ZERO
4.4
Setpoints
The MSI-8000HD supports eight setpoints. Common uses of setpoints are for warnings or process control. It comes
standard with LED outputs for a triggered set point.
to zero out any initial error.
, so there is no need to program F1 or F2 to Print. Then pushing F1 or F2 on the
F-3 key
Fx-ttl.rd
, the time limit is reset.
d
F1
and
.
displays.
POWER
.
Figure 4-1. Setpoint LED's
LED blinks continuously at a slow rate.
Fx
Pairs
will scroll through the available combinations.
, or the battery dies.
POWER
displays.
Fx-HiRes
key is used for
F3-Print
or
modes are enabled in the
Both
Setpoint 1 is Blue
Setpoint 2 is Green
Setpoint 3 is Red
Setup
is
11