BONFIGLIOLI ACTIVE Manual page 42

Note:
If transition 5 has been triggered with
control word is only accepted after the completion of the transition process. The
change of state from "Operation enabled" to "Ready" is done after the expiry of the
time
If the parameter
can be set back to 0x0F during the stoppage of the drive. In this way, the drive runs
back up to its set reference value and remains in the state "Operation enabled".
The change of state from "Operation enabled" to "Ready" is done after the set switch-
off threshold has been reached and expiry of the set holding time (equivalent to the
behavior in a quick stop). In this, the parameters
fmax) and
relevant.
40
40
The default value for the parameter
mode "2 – Ramp". For configurations with torque control, the default
value is operation mode "0 - Coast to stop". In a switch-over of the
configuration, the setting value for
necessary.
Braking time
632 parameterized for the DC brake.
State transition 5
Holding time
638 (holding time after switch-off threshold reached) are
State transition 5
State transition 5
State transition 5
392 = "1 - DC brake", a new
392 = "2 - Ramp" has been set, the control word
Switch-off threshold
392 is operation
392 is also altered if
637 (percent of
06/05
06/05