5.4.99 route default
Description Set default route
Syntax
Parameter
5.4.100 route delete
Description Delete routing from route table
Syntax
Parameter
5.4.101 runningcfg active partition
Description There are two memory partitions for storing the configuration data.
Syntax
Parameter
route default <ipv4 address>
Name
<ipv4 address> Default route IP address.
route delete <ipv4 address> netmask <ipv4 address>
Name
<ipv4 address> IP address.
This command allows you to select the flash boot point (partition)
for next power-on.
runningcfg active partition <number>
Name
<number>
Valid values: xxx.xxx.xxx.xxx (xxx:0~255)
Default value: -
Type: Mandatory
Description
Valid values: xxx.xxx.xxx.xxx (xxx:0~255)
Default value: -
Type: Mandatory
Description
Valid values: xxx.xxx.xxx.xxx (xxx:0~255)
Default value: -
Type: Mandatory
Description
Partition number
Valid values: 1~2
Default value: -
Type: Mandatory
- 275 -