5.3 Enable Mode Commands
The commands in this section can be executed only in the Enable execution mode.
5.3.1 configure
Description
Syntax
Parameter
5.3.2 ping
Description
Syntax
Parameter
5.3.3 show access-list bcrate
Description
Syntax
Parameter
5.3.4 show access-list dstip
Description
Syntax
Parameter
Go to Configure execution mode from Enable mode.
configure
None
ICMP echo and reply from hostname address or IP address. If no
reply for a long time, you can press Ctrl + c to interrupt ping.
ping {ipv4 address}
ping {ipv4 address} count <count>
ping {ipv4 address} size <size>
ping {ipv4 address} count <count> size <size>
Name
Description
ipv4 address
IPv4 address.
Valid values: xxx.xxx.xxx.xxx (xxx:0~255)
Default value: -
count
The number of PING packets sent.
Default value: -
size
Packet size.
Default value: -
Display all broadcast rate limiting list
show access-list bcrate
None
Display all dest IP deny access list or by index
show access-list dstip [<index>]
Name
Description
<index>
Destination IP deny access list number.
Valid values: 1 ~ 256
- 216 -