Dhcp Server; Dhcp Server Mode Configuration - Planet GS-5220 User Manual
L3 gigabit/10 gigabit managed poe switch
Hide thumbs
Also See for GS-5220:
- User manual (568 pages) ,
- Quick installation manual (16 pages) ,
- Quick installation manual (16 pages)
Table of Contents
Advertisement
4.2.4 DHCP server
4.2.4.1 DHCP Server Mode Configuration
Configure DHCP server mode on this page. The entry index key is ID.; screen in
The page includes the following fields:
Object
• Mode
• VLAN Mode
• VLAN Range
• Mode
User's Manual of GS-5220 PoE Series Managed Switch
Figure 4-2-4-1: DHCP server mode Page Screenshot
Description
Configure the operation mode per system. Possible modes are:
Enabled: Enable DHCP server per system.
Disabled: Disable DHCP server pre system.
Configure operation mode to enable/disable DHCP server per VLAN.
Indicate the VLAN range in which DHCP server is enabled or disabled. The first
VLAN ID must be smaller than or equal to the second VLAN ID. BUT, if the VLAN
range contains only 1 VLAN ID, then you can just input it into either one of the
first and second VLAN ID or both.
On the other hand, if you want to disable existed VLAN range, then you can
follow the steps.
1.
press to add a new VLAN range.
2.
2. input the VLAN range that you want to disable.
3.
3. choose Mode to be Disabled.
4.
4. press to apply the change.
Then, you will see the disabled VLAN range is removed from the DHCP Server
mode configuration page.
Indicate the operation mode per VLAN. Possible modes are:
Enabled: Enable DHCP server per VLAN.
111
Figure 4-2-4-1
appears.
Advertisement
Table of Contents
