Computer Setup Main - HP Z Series Maintenance And Service Manual

NOTE:
application. You can access this application directly by pressing
3. Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down)
keys to select the option you want, and then press enter. To return to the Computer Setup Utilities
menu, press esc.
4. To apply and save changes, select Main > Save Changes and Exit.
● If you have made changes that you do not want applied, select Ignore Changes and Exit.
● To restore settings from the Advanced and Main menus to original values, select Apply Factory
Defaults and Exit.
●
To restore settings from the Advanced and Main menus to those previously saved by Save
Custom Defaults, select Apply Custom Defaults and Exit. If no custom defaults have been
saved, factory defaults are used.
NOTE:
those values by selecting Restore Security Settings to Factory Defaults at the bottom of the
Security menu.
NOTE:
IMPORTANT:
changes because the settings could become corrupted. It is safe to turn off the computer only after
exiting the F10 Setup screen.

Computer Setup Main

This table provides information about the Computer Setup Main menu.
NOTE: Support for specific Computer Setup options can vary, depending on the hardware
configuration.
56 Chapter 6 Computer Setup (F10) Utility
Selecting UEFI Drivers restarts the computer into the third-party option ROM management
You cannot modify settings in the Security menu by selecting Apply Defaults. You reset
Not all settings shown in the following sections are available for all models.
Do not turn computer power off while the BIOS is saving the Computer Setup (F10)
f3 during startup.