Solid-State Drive - HP ProDesk 480 G6 MT Maintenance And Service Manual

Solid-state drive

Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the front bezel (see
4. Remove the drive cage (see
Remove the solid-state drive:
1. Remove the Phillips screw (1) that secures the solid-state drive to the computer chassis.
2. Remove the solid-state drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to install the solid-state drive.
42 Chapter 4 Removal and replacement procedures
Access panel on page
Front bezel on page
Drive cage on page
Solid-state drives are designed with notches to prevent incorrect insertion.
Preparation for disassembly on page
32).
35).
36).
31).